Filter
Top Products
Powering the Camcorder
13
Charging the Battery
If the DC cable is attached to the
DC OUT jack on the Adapter/Charger,
remove it.
1. Make sure the arrow on the
battery faces up and points to the
Adapter/Charger’s POWER light.
2. Hold the battery flush against the
Adapter/Charger and slide it in
the direction of the arrow.
3. Plug the Adapter/Charger into the
nearest AC power outlet (100-
240V, 50/60Hz).
4. If the battery is properly
connected, the CHARGE
indicator blinks.
Note: If you try to charge a battery
that has not been charged for a long
period of time, it may take a few
minutes for the CHARGE indicator
to flash.
5. After the battery is charged, the
CHARGE indicator stops
blinking and remains lit.
6. Remove the charged battery by
sliding it off the Adapter/Charger.
7. Attach the charged battery to the
camcorder as described on the
previous page.
To AC Wall Outlet
100-240 Volts, 50/60 Hz.
CHARGE Indicator
Adapter/Charger
model 247801
Lithium-ion
Rechargeable Battery
model 247800 (or
optional model BB46L)
POWER Indicator
Arrow Marker
DC OUT Jack
CAUTION
When a battery is attached to the Adapter/Charger, do not turn them
upside down. The battery may fall off and be damaged or cause injury.