Sanyo VQM-801P Security Camera User Manual


 
BASIC OPERATIONS
SECURITY LOCK FUNCTION
This function lets you lock the camera live picture mode or VCR
playback mode, so that it cannot be switched to another mode.
Security lock
Press the LIVE or the VCR button for about 3 seconds.
The buzzer will be heard and all the buttons will be locked. If a
button is pressed by mistake, the buzzer is heard and the
corresponding function will not operate.
Canceling the Security Lock
To cancel the security lock, press the same (LIVE or VCR)
button again for about 3 seconds. A buzzer will be heard and the
mode will be unlocked.
SETTINGS BACKUP FUNCTION
This unit is equipped with a backup battery (lithium battery) to
maintain the clock settings. When the unit is used under normal
conditions, the backup battery is recharged. The battery is fully
recharged after a minimum of about 30 hours, and will maintain
the clock settings for up to 30 days.
NOTE: The settings may not be maintained properly if the
backup battery has been recharged for less than 30
hours when the power goes off.
Battery Life
If the power is turned off for about one hour or more, when the
power is restored, the (CLOCK SET) menu is displayed so the
clock settings can be checked.
If the clock settings are reset to: 01-01-2000 SAT 00:00:00, that
may indicate that the battery is dead and must be replaced.
Replacing the Battery
To replace the battery, please consult your dealer. After the
battery has been replaced, press the ALL RESET button, then
in the (CLOCK SET) menu set the date and time (see page 17).
RESET FUNCTION
The menus can be reset or cleared.
Using the MENU RESET Button
A: While a menu is displayed, press the MENU RESET button
to reset all the values of the displayed menu to the default
values.
B: If no menu is displayed, press the MENU RESET button to
reset the time to the nearest hour.
NOTE: For example, between 10:30:00 and 11:29:59 the
clock will be reset to 11:00:00.
Using the ALL RESET button
Press this button to reset the following:
Reset the time and date in the (CLOCK SET) menu to the
default setting.
The display will return to the default quad screen display
mode.
NOTE: If the unit does not function properly, press the
ALL RESET button.
Please note that all the settings mentioned above
will be reset.
LIVE
or
VCR
LIVE VCR MENU
MENU RESET
ALL RESET
L8QR5/XE (VQC-801P, VQM-801P GB) 1999. 12. 2
8 English