Sharp VL-WD450U Camcorder User Manual


 
10
Preparation
Attaching and Removing the
Battery Pack
Attaching the Battery Pack
1 Make sure that the Power switch is set
to OFF.
Power switch
2 Lift up the viewfinder.
Power source
mounting surface
3 Align the - mark on the side of the
battery pack with the q mark on the
camcorder (1), and slide the battery
pack down completely until it locks into
place (2).
4 Lower the viewfinder.
Removing the Battery Pack
1 Perform steps 1 and 2 above.
Power source PUSH
release button
2 Press the power source PUSH release
button (1), and slide the battery pack
up and take it out (2).
Cautions:
BEFORE REMOVING THE BATTERY PACK,
ALWAYS STOP RECORDING OR PLAYBACK
AND TURN THE POWER OFF. Removing the
battery pack while shooting or during playback
may damage the tape by causing it to wrap
around the video head drum or may destroy the
SmartMedia card, rendering it unreadable and
unwritable.
Remove the battery pack from the camcorder if
you will not use the camcorder for a long period
of time.
Use only SHARP model BT-L221 or BT-L441
battery packs with this camcorder. Use of other
batteries may present a risk of fire or explosion.