Sharp VL-WD450U Camcorder User Manual


 
44
Useful Features
3 Press d or y to select ON, then
press e.
REMOTE
ON
4 Press the MENU/DISPLAY button to
turn off the menu screen.
Operating the Remote Control
1 Open the LCD monitor completely (1),
then rotate it 180° vertically (2).
90
180
2 Set the Media Selection switch on the
camcorder to TAPE or CARD.
3 Set the Power switch on the camcorder
to CAMERA or VCR.
4 Aim the remote control at the remote
sensor of the camcorder, and press the
control buttons for operation.
Notes:
Be careful not to allow direct sunlight or bright
light from interior illumination to fall onto the
remote sensor, as this may prevent the remote
control from operating properly.
Be sure that there are no obstacles between the
remote control and the remote sensor.
When the batteries are depleted and the remote
control does not operate, replace them with new
AA (R6 or UM/SUM-3) batteries.
Remote sensor
16 ft
(5 m)
Approximate operating
range of remote control
TAPE REC START/STOP button [p. 20]
CARD REC button [p. 74]
ZOOM W/T buttons
[pp. 21, 60]
REW button [pp. 23, 78]
PLAY button
[pp. 23, 78]
FF button
[pp. 23, 78]
PAUSE/STILL button [pp. 25, 45]
STOP button
[pp. 23, 78]
SLOW button
[p. 45]
Advance/reverse buttons [p. 45]
Shift buttons [p. 60]
VOL. +/L buttons
[p. 23]