Filter
Top Products
Chapter 4 Menu Operations
Chapter 4 Menu Operations 4-13
Remote Control Menu (Enhanced Menu)
The Remote Control Menu is an enhanced menu and is
displayed only when MENU GRADE is set to ENH on
the top menu.
Monitor Display
SETUP MENU
REMOTE CONTROL MENU
RS232C : 9600
PARALLEL INPUT
PARALLEL OUTPUT
PARALLEL OUT VOLTAGE
Character display
Remote Menu
↓ Press the b key.
>RS232C
The Remote Control menu item selected when you left the
menu the last time is displayed.
The setting shown in bold characters in the Layer 3 or 4
column of the table is the standard setting and is displayed
with an asterisk on the monitor screen.
Display Char. display Contents
Layer 2 Layer 3 Layer 4
RS232C >RS232C For setting the baud rate for the RS-232C interface.
n BPS (9600) >>n bps n = 1200/2400/4800/9600/19200/38400
PARALLEL INPUT >Para Input For assigning a function to each input pin (24 inputs) of the
PARALLEL I/O connector on the rear panel.
INm (n PIN) >>n PIN m = 1 to 24, n = pin number 2 to 13, 21 to 32
NO USE >>>No use Ignores the input signal.
STOP >>>STOP Command inputs corresponding to the tape transport
REC >>>REC control keys on the front panel (Active L)
PLAY >>>PLAY
F.FWD >>>F.FWD
REW >>>REW
F.FRAME >>>F.FRAME
R.FRAME >>>R.FRAME
SERIES REC >>>SerRec Series-recording signal input (Active L)
TIME ADJUST >>>Time Set Clock set signal input (Active L).
The internal clock will be set to 00 minute 00 second within ±15
minutes when the signal is input.
ALARM RETURN
>>>AlmRtn Alarm return input (Active L)
ALARM (L) >>>Alarm L Alarm input common to all cameras (Active L)
ALARM n (L) >>>Alm n L Independent alarm input to camera n (Active L)
n = Camera No. 1 to 16
ALARM (H) >>>Alarm H Alarm input common to all cameras (Active H)
ALARM n (H) >>>Alm n H Independent alarm input to camera n (Active H)
n = Camera No. 1 to 16
(Continued)