Filter
Top Products
21
Getting Started
Step 3: Charging the battery pack
You can charge the “InfoLITHIUM”
battery pack (L series) (p. 98) after
attaching it to your camcorder.
b Notes
• You cannot attach any “InfoLITHIUM” battery
pack other than the L series to your camcorder.
1 Attach the battery pack to your
camcorder.
Attach the battery pack by sliding it in
the direction of the arrow while pressing
it until it clicks.
2 Slide the POWER switch to OFF
(CHG).
3 Connect the AC Adaptor to the
DC IN jack of your camcorder. Be
sure that the v mark on the DC
plug is facing to the v mark on
your camcorder.
4 Connect the power cord (mains
lead) to the AC Adaptor and the
wall outlet (wall socket).
The CHG (charge) lamp lights up and
charging starts. The CHG (charge) lamp
turns off when the battery is fully
charged.
b Notes
• Disconnect the AC Adaptor from the DC IN
jack holding both the camcorder and the DC
plug.
z Tips
• You can operate your camcorder connected to a
power source such as a wall outlet (wall socket)
as shown in the illustration. The battery pack
will not lose its charge in this case.
4
3
2
1
Battery pack
To the wall outlet
(wall socket)
Power cord
(Mains lead)
AC Adaptor
POWER
switch
DC plug
DC IN
jack
CHG
(charge)
lamp
Continued ,