Sony HVR-HD1000E Camcorder User Manual


 
62
x VF B.LIGHT
You can adjust the brightness of the
viewfinder.
BNORMAL
Standard brightness.
BRIGHT
Brightens the viewfinder screen.
x VF COLOR
BON
Display pictures in the viewfinder in color.
OFF
Display pictures in the viewfinder in black
and white.
b Notes
When you connect your camcorder to outside
power sources, [BRIGHT] is automatically
selected for the setting.
When you select [BRIGHT], battery life is
slightly reduced during recording.
Select [COMPONENT] when connecting
your camcorder to a TV with the
component input jack.
576i
Select when connecting your camcorder to
a TV with the component input jack.
B1080i/576i
Select when connecting your camcorder to
a TV that has the component input jack
and is capable of displaying the 1080i
signal.
You can set an output video signal type
from HDV format signals.
x i.LINK CONV
When set to [ON:SQUEEZE]/[ON:EDGE
CROP], converts the HDV signal to the DV
format and output it from the HDV/DV
Interface (i.LINK). The DV format signal is
output unchanged.
B OFF
ON:SQUEZE
Output signals to a 16:9 wide TV or a TV
compatible with 16:9 wide mode.
ON:EDGE CROP
Display the center of the picture in 4:3
aspect ratio by cropping the both sides of
the picture.
b Notes
For an i.LINK input, refer to “VCR HDV/DV”
(p. 59).
Be sure to disconnect the i.LINK cable before
changing the setting. Otherwise, the connected
device may not be able to recognize the video
signal properly.
x VIDEO OUT
You can set the HDV output format for the
following outputs.
– COMPONENT (576i)
– S VIDEO
–AUDIO/VIDEO
B SQUEZE
Output signals to a 16:9 wide TV or a TV
compatible with 16:9 wide mode.
COMPONENT
DOWN CONVERT
On a 4:3 TV
compatible with
16:9 wide mode
On a 16:9 wide TV
On a 4:3
standard TV
STANDARD SET SET menu (Continued)