Filter
Top Products
13
MZ-R501/R501PC
4-8. Self-Diagnosis Result Display Mode
This set uses the self-diagnostic function system in which if an
error occurred during the recording or playing, the mechanism
control block and the power supply control block in the
microcomputer detect it and record its cause as history in the
nonvolatile memory.
By checking this history in the test mode, you can analyze a fault
and determine its location.
Total recording time is recorded as a guideline of how long the
optical pickup has been used, and by comparing it with the total
recording time at the time when an error occurred in the self-
diagnosis result display mode, you can determine when the error
occurred.
Clear both self-diagnosis history data and total recording time, if
the optical pickup was replaced.
• Self-Diagnosis Result Display Mode Setting Method
1. Setting the test mode (see page 11).
2. In the display check mode, press the [ENTER] key activates the
self-diagnosis result display mode where the LCD display as
shown below.
3. Then, each time the
> key is pressed, LCD display descends
by one as shown below. Also, the LCD display ascends by one
when the
. key is pressed.
4. Quit the self-diagnosis result display mode, and press the x key
to return to the test mode (display check mode).
5. The display changes a shown below each time the
[ENTER] key on the set is pressed.
However in the power mode (item number 700’s), only the
item is displayed.
6. Quit the manual mode, and press the
x key to return to the
test mode (display check mode).
4-7. Overall Adjustment Mode
Mode to adjust the servo automatically in all items.
Normally, automatic adjustment is executed in this mode at the
repair.
For further information, refer to “Section 5 Electrical Adjustments”
(see page 17).
This set LCD display
item number
adjustment valu
e
address
• Address & Adjusted Value Display
This set LCD display
jitter value
• Jitter Value & Adjusted Value Display
This set LCD display
• Block Error Value & Adjusted Value Display
This set LCD display
• ADIP Error Value & Adjusted Value Display
This set LCD display
• Item Title Display
0 113A4S1D
item number
adjustment valu
e
0 11OFEJ1D
item number
adjustment valu
e
block error value
0 11063B1D
item number
adjustment valu
e
ADIP error value
0 11072A1D
item number
item title
0 11LrefPw
This set LCD display
error
display code
history code
Total recording time
when error occurred
0 XX1 0000
0 XX1
0 XXN
0 XXN1
0 XXN2
0 XXR_
XX
:Error code
:Total recording time