Filter
Top Products
Operating the Camera
Capturing a Monitor Image
15
Recording a Still Image on an ATA
Memory Card or the Built-in
Memory of the Camera
If you select Memory save and click , the current
still image is captured and stored in the memory
specified on the Image memory setting page.
To use this function, you need to select the Use image
memory function option and the Manual mode on the
Image memory setting page.
For details, see “Recording Images in Memory — Image
memory setting Page” on page 41.
Note
If the camera is installed on a desk top, the recorded still
image is upside down.
Controlling Alarm Output
If you select Alarm out 1 or Alarm out 2 and click ,
you can control alarm out 1 or alarm out 2 of the I/O port
on the camera manually. Each click switches the relay
between short-circuit and open alternately.
To use this function, you need to select the Use alarm
out 1 (or 2) function option and the Manual mode on
the Alarm out 1 or Alarm out 2 setting page.
For details, see “Setting the Alarm Out 1 or 2 — Alarm
out 1 or 2 setting Page” on page 40.
For the connection of peripheral devices to the Alarm
out of the I/O port, see the supplied Installation Manual.
Selecting the Day/Night Mode
If you select Day/Night and click , you can select
the Day/Night mode. Each click switches between the
day mode and night mode.
To use this function, you need to select the Day/Night
mode menu on the Camera setting page to Manual.
For details, see “Setting the Camera — Camera setting
Page” on page 25.
Capturing a Monitor
Image
If you click the Capture button on the menu section,
the current still image is captured and displayed on the
monitor image section.
Note
If the camera is installed on a desk top, the captured still
image is upside down.
To save the captured image
Right-click on the monitor image and select Save As
from the menu. Then, the Save Picture dialog appears.
Type the file name and specify the destination to which
the image file is to be stored, and click Save. The image
is saved in the JPEG format.