Filter
Top Products
Administrating the Camera
Configuring the Network — Network setting Page
28
HTTP port setting Section
You can set the port number for the HTTP server on the
camera.
HTTP port No.
Normally select 80. If you want to use a port number
other than 80, select the text box and type a port number
between 1024 and 65535.
Note
When you have set the HTTP port No. to a number other
than 80 on the Network setting page or in the Setup
Program, access the camera by typing the IP address of
the camera on the web browser, as follows:
Example: when HTTP port No. is set to 8000
Notifying the IP Address
— Dynamic IP address notification
Section
When the DHCP menu is set to On, you can send the
notification of the completion of the network settings
(Wired LAN settings and Wireless LAN settings) using
the SMTP or HTTP protocol.
SMTP
Select On to send an E-mail when the DHCP setting is
completed.
SMTP server name
Type the name or IP address of the SMTP server you
want to use for sending an E-mail, up to 64 characters.
Recipient e-mail address
Type the recipient E-mail address up to 64 characters.
You can specify only one recipient E-mail address.
From e-mail address
Type the E-mail address that is displayed in the From
field of E-mails, up to 64 characters. This is used as the
reply address or the address for the system mail from the
mail server.
Subject
Type the subject/title of the E-mail up to 64 characters.
Message
Type the text of the E-mail up to 384 characters. You
can describe the information of the acquired IP address,
etc. using the special tags mentioned below.
HTTP
Select On to output a command to the HTTP server
when the DHCP setting is completed. Using this
function, you can configure a useful system, for
example, to view the access log stored in the HTTP
server or start an external CGI program.