Filter
Top Products
Administrating the Camera
Configuring the Network — Network setting Page
27
DHCP
Select On to assign the IP address to the camera
automatically. When you have assigned a proper IP
address to the camera, select Off.
Note
When you set DHCP to On, make sure that there is an
DHCP server on the network.
DNS auto acquisition
When DHCP is set to On, select if the IP address of the
DNS server is assigned automatically or not. Select On
to assign the IP address of the DNS server automatically.
IP address
Type the IP address of the camera.
Subnet mask
Type the subnet mask.
Default gateway
Type the default gateway.
MAC address
Displays the MAC address of the wireless LAN card
inserted into the PC card slot of the camera. If no card
is inserted, 00-00-00-00-00-00 is displayed.
Primary DNS
Type the IP address of the primary DNS server.
Secondary DNS
Type the IP address of the secondary DNS server, if
necessary.
Bandwidth control
Limits the data communication bandwidth for the
wireless interface of the camera.
You can select from among the following:
Unlimited, 0.5, 0.6, 0.7, 0.8, 0.9, 1.0, 2.0, 3.0 (Mbps)
Select Unlimited when you do not want to limit the
bandwidth.
SSID
Type the ID to identify the wireless network you want to
access using up to 32 ASCII characters (upper and lower
cases).
For your security, be sure to change the factory setting.
Type
Select the network connection type 802.11 Ad hoc
mode or Infrastructure mode. When you select 802.11
Ad hoc mode, specify the wireless channel and the
maximum transmission power.
Specify the channel and transmission power conforming
to the regulations of your country or region. For details,
refer to the Operation Manual and Installation Guide of
the wireless LAN card.
WEP
Select On when you use the WEP (Wired Equivalent
Privacy) keys, or Off when you do not use it.
The WEP key data settings are valid only when the WEP
menu is set to On.
WEP key data
Specify up to 4 WEP keys. The length of a WEP key is
40 or 104 bit. A 104-bit WEP key has a higher security
level than a 40-bit key. You can type the WEP key either
in hexadecimal numbers (0 to 9 and A to F) or ASCII
characters.
When the Type menu is set to Infrastructure mode, the
WEP key should be the same as that of the access point.
When the Type menu is set to 802.11 Ad hoc mode, the
WEP key should be the same as that of the
communication client.
Notes
• Before removing the wireless LAN card from the
camera, turn off the power of the camera.
• If a setting either in the Wired LAN setting section or
the Wireless LAN setting section has changed, both
the Ethernet and wireless interfaces are disconnected
and initialized.
• The throughput of the data transmission/reception via
the Ethernet may decrease when the wireless LAN
card is in use.