Filter
Top Products
23
Advanced operations
Advanced operations
Using alternative power sources
You can choose any of the following power sources for your camcorder: battery pack, house
current, and 12/24 V car battery. Choose the appropriate power source depending on where
you want to use your camcorder.
Place Power source Accessory to be used
Indoors House current Supplied AC power adaptor
Outdoors Battery pack Battery pack NP-F330 (supplied), NP-F530, NP-F550, NP-
F730, NP-F750, NP-F930, NP-F950
In the car 12 V or 24 V car battery Sony DC adaptor/charger DC-V700
Note on power sources
Disconnecting the power source or removing the battery pack during recording or playback
may damage the inserted tape. If this happens, restore the power supply again immediately.
Using the house current
To use the supplied AC power adaptor:
(1)Connect the power cord to a wall outlet.
(2)Lift up the viewfinder.
(3)Slide the connecting plate down into the guides at the rear of the camcorder until it clicks.
To remove the connecting plate
The connecting plate is removed in the same way as the battery pack.
WARNING
The power cord must only be changed at a qualified service shop.
PRECAUTION
The set is not disconnected from the AC power source (house current) as long as it is
connected to the power cord, even if the set itself has been turned off.
Using a car battery
Use a DC adaptor/charger such as Sony DC-V700 (not supplied). Connect the car battery
cord to the cigarette lighter socket of a car (12 V or 24 V). Connect the DC adaptor/charger
and the camcorder using the DK-415 (supplied with DC-V700) connecting cord.
This mark indicates that this product is a genuine accessory for Sony video
product.
When purchasing Sony video products, Sony recommends that you purchase
accessories with this “GENUINE VIDEO ACCESSORIES” mark.
1
2
3