Sony DCR-TRV9 Camcorder User Manual


 
76
AC power adaptor
Charging
Use only an “InfoLITHIUM” type battery pack.
Place the battery pack on a flat surface without vibration during charging.
The battery pack will get hot during charging. This is normal.
Others
Unplug the unit from the wall outlet when not in use for a long time. To disconnect the
power cord, pull it out by the plug. Never pull the cord itself.
Do not operate the unit with a damaged cord or if the unit has been dropped or damaged.
Do not bend the AC power cord forcibly, or put a heavy object on it. This will damage the
cord and may cause a fire or an electrical shock.
Be sure that nothing metallic comes into contact with the metal parts of the connecting
plate. If this happens, a short may occur and the unit may be damaged.
Always keep the metal contacts clean.
Do not disassemble the unit.
Do not apply mechanical shock or drop the unit.
While the unit is in use, particularly during charging, keep it away from AM receivers and
video equipment because it will disturb AM reception and video operation.
The unit becomes warm while in use. This is normal.
Do not place the unit in locations that are:
Extremely hot or cold, Dusty or dirty, Very humid, Vibrating
Note on dry batteries
To avoid possible damage from battery leakage or corrosion, observe the following.
Be sure to insert the batteries in the correct direction.
Dry batteries are not rechargeable.
Do not use a combination of new and old batteries.
Do not use different types of batteries.
The batteries slowly discharge while not in use.
Do not use a battery that is leaking.
If battery leakage occurred
Wipe off the liquid in the battery case carefully before replacing the batteries.
If you touch the liquid, wash it off with water.
If the liquid get into your eyes, wash your eyes with a lot of water and then consult a
doctor.
If any difficulty should arise, unplug the unit and contact your nearest Sony dealer.
Maintenance information and precautions