Filter
Top Products
9
Getting started
Charging and installing the battery pack
Notes on charging the battery pack
• The CHARGE lamp will remain lit for a while even if the battery pack is removed and the
power cord is unplugged after charging the battery pack. This is normal.
• If the CHARGE lamp does not light, disconnect the power cord. After about one minute,
reconnect the power cord again.
• You cannot charge the battery pack while you operate the camcorder using the AC power
adaptor.
•
When a fully charged battery pack is installed, the CHARGE lamp will light once, then go out.
Installing the battery pack
(1)Lift up the viewfinder.
(2)Insert the battery pack in the direction of the $ mark on the battery pack. Slide the
battery pack down until it is locked.
Attach the battery pack to the camcorder securely.
Note on installing the NP-F730/F750 battery pack
Use the camcoder while stretching out the viewfinder. Be careful not to catch your finger in
when you fold the viewfinder back to the original position.
Note on installing the NP-F930/F950 battery pack [a]
Use the camcorder while lifting up the viewfinder.
When you install the viewfinder adaptor, you can record a picture with stretching out the
viewfinder while using the NP-F930/F950 battery pack.
Install the viewfinder adaptor by matching the adaptor groove and the finder tip shown in
the figure. An eclipse may appear in the finder if you use the adaptor. This will not affect the
recorded image.
Note on the battery pack
Do not carry the camcorder by grasping the battery pack.
To remove the battery pack [b]
While pressing BATT, slide the battery pack in the direction of the arrow.
You can look at the demonstration of the functions available with this camcorder (p. 26).
1
2
[b]
[a]
Viewfinder adaptor
BATT