Filter
Top Products
59
Advanced operations
Using the Remote Commander, you can easily go back to the desired point on a tape after
playback.
(1) During playback, press ZERO SET MEMORY at the point you later want to locate. The
counter shows “0:00:00” and “ZERO SET MEMORY” appears on the LCD screen or in the
viewfinder.
(2) Press p when you want to stop playback.
(3) Press 0 to rewind or press ) to fast-forward the tape to the counter’s zero point. The
tape stops automatically when the counter reaches approximately zero. “ZERO SET
MEMORY” disappears and the time code appears.
(4) Press ·.
Note on the tape counter
There may be a discrepancy of several seconds from the time code.
Notes on ZERO SET MEMORY
• When you press ZERO SET MEMORY, the counter’s zero point is memorized. Press
ZERO SET MEMORY again before step 3 to cancel the memory .
• ZERO SET MEMORY may not function when there is a blank portion between pictures on
a tape.
• ZERO SET MEMORY functions in recording standby mode.
Returning to a pre-registered position
0:00:00
ZERO SET
MEMORY
0:00:00
1
24
3