Filter
Top Products
1-5
Getting Started
1. Connect the wand emulation interface cable (p/n 25-39803-01) to the bottom of the
scanner, as described in
Installing the Cable
on page 1-2.
2. Connect the other end of the interface cable into the COM port on the PDT or
Controller.
Figure 1-3. Wand Emulation Connection
3. Plug one end of the power cable into the power receptacle on the interface cable, and
plug the other end into a wall outlet.
Keyboard Wedge Connection
When configured for keyboard wedge input, the host accepts input from the scanner as
keystrokes. The P 300 can perform keyboard wedge input using a keyboard wedge cable, or
via the Synapse cable.
To connect the keyboard wedge cable:
1. Connect the keyboard wedge interface cable (p/n 25-38699-01) to the bottom of the
scanner, as described in
Installing the Cable
on page 1-2.