Filter
Top Products
4
TANDBERG FieldView Device User Guide
D14041.02 January 2008
2. FieldView Device Basic Operation
2.1. ChargingtheBattery
New batteries should be charged prior to rst use. To do this, plug in the
external power adapter and allow the battery to charge until the orange
battery indicator extinguishes (up to eight hours). The internal battery charger
will shut itself off to prevent overcharging once the battery is fully charged.
Note that the FieldView Device shuts itself off when battery power is low.
• If the unit is on, and an Operator is using it in an active call, a warning
message appears so that the Operator has time to plug the FieldView Device
in to the external power adapter, or end the call before the FieldView Device
shuts off.
• If the unit is in Standby, it simply shuts itself off.
• If the unit is off, it cannot be started when the battery is low.
To check current battery levels, press the Display button once and check the
Session information at the bottom of the Viewnder. See page 14 for more
information on Viewnder and Display modes.
2.2. InsertingorReplacingtheBattery
Important: Before using this device for the rst time you must install and
charge the battery. Here’s how (refer to gures at right):
1. Open the battery compartment and insert the battery until it clicks into
place and is ush. It only ts one way.
2. Close the battery door as follows:
• Ensure the lock switch is in the Un-locked position.
• Orient the battery door so it is at against the battery well, but with a
3mm gap (as shown in the lower gure).
• Slide the door toward the center of the FieldView Device until it is fully
closed.
• Slide the lock switch to the Locked position.
3. Connect the FieldView Device to the external power adapter and charge the
battery until the orange LED turns off (up to 8 hours).
Note: The device will not operate on the external adapter alone. You must
have a battery installed.
Gap
Figure 3
Figure 1
Locked
Un-locked
Figure 2