Filter
Top Products
SCANNING FROM THE TWAIN INTERFACE 37
SETTING UP YOUR SCANNER TO WORK WITH PAPERPORT
When you select a scanning option on the PaperPort window from the
Scanner drop-down list, either TWAIN: Visioneer 9420 or WIA:
Visioneer 9420 (Windows XP only), the Scan button at the bottom of
the panel should become active. If it doesn’t, you need to set up
PaperPort to work with your scanner.
Note: Setting up your scanner is a one-time-only process for each
option from the Scanner drop-down list. Therefore, you may have to
set up your scanner once each for TWAIN: Visioneer 9420 and
WIA: Visioneer 9420. The setup process, described below, is the
same for each option. You will not have to set up the scanner again
for an option unless you uninstall the scanner and PaperPort
software, then re-install them.
If this Scan button is not active, you need to
set up PaperPort to work with your scanner.