Filter
Top Products
QSP-660: Instructions for Basic Operation and Installation
Page 17
H
AND
H
ELD
IR R
EMOTE
C
ONTROL
The hand held remote control allows easy remote operation of your QSP-660
by duplicating the front panel buttons as shown in the diagram. One major
difference between front panel and remote operation is that the individual
camera buttons have been reduced to a single button. In this case, the first
press of the camera button will cause the QSP-660 to display camera 1.
Additional button presses will cycle the selection through each available
camera and back to camera 1.
Please note that the remote control may not work properly in the presence of
strong sun light.
Programming your ATV QSP-660 Remote Control
When first installing or when changing the batteries in your QSP-660 Remote
Control, it may be necessary to reprogram it for use with the
QSP-660.
Note:
If your remote control does not appear to work for any
reason, please perform the following steps.
To program the remote control to work with the QSP-660:
1. Ensure that batteries are properly installed in the QSP-660 Remote
Control.
2. Turn on the QSP-660 and connect a monitor.
3. On the QSP-660, press the
DISPLAY
button to return to
DISPLAY
mode. Then press any of the
1
-
4
buttons to call up a full screen picture.
4. On the remote control, press and hold the
VCR
button followed by the
DISPLAY.
Hold both buttons together until the indicator lights up and
blinks twice.
5. Enter your five-digit code. The QSP-660 code set #1 equates to remote code 11414, and code set #2
equates to code set 11344. The red LED will now blink twice and the remote control is set. Your QSP-
660 is factory set for Code set #2. See page 16 to change the QSP-660 Code set.
The codes are entered by using the four buttons shown in the above diagram (
Freeze
,
Camera
,
Quadrant
,
PIP
). For example, to enter the default code for a QSP-660
(code 11344) press the
following:
Code set #1 Code set #2
FREEZE 2 TIMES FREEZE 2 TIMES
QUADRANT 1 TIME PIP 1 TIMES
FREEZE 1 TIME QUADRANT 2 TIMES
QUADRANT 1 TIME
Press the
DISPLAY
button on the remote control for quad display on the QSP-660.
Note
: After replacing the battery, you must re-program the remote.