Filter
Top Products
QSP-660: Instructions for Basic Operation and Installation
Page 7
R
EMOTE
C
ONTROL
O
PERATION
The IR remote control provided with your QSP-660 has a limited set of buttons. Operation with the remote
control is slightly different than the front panel. The remote control has a single CAMERA button for selecting
cameras and successive button presses will rotate through the available cameras. Sequencing is initiated by
pressing and holding the remote control’s FREEZE button for approximately 3 seconds. Pressing the
QUADRANT button anytime in VCR playback accesses the ZOOM function.
Note:
Menus are not available through the remote control. The remote control must be
programmed when the batteries are removed. See “Programming Your ATV QSP-660 Remote
Control” on page 17.