Filter
Top Products
153
Solution
Rotate the function dial to and slide the power
switch to turn on the camera.
Replace all four batteries or use the AC adapter
( sold separately ).
Remove the batteries and then insert the batteries by
following the +/- diagram indicated in front of the bat-
tery-chamber door.
When "NO CARD" is displayed on the LCD monitor and
"CF" is displayed on the data panel, the CF card is not
installed. Install the CF card.
Slide the power switch to turn on the camera.
The camera is busy reading the image data from the
CF card. Simply wait until this function is complete
and "PLAY BACK" stops blinking on the LCD monitor.
Retake the photo within the flash range ( 0.4 to 3 m ) .
Problem
The image
will not play
back on
the LCD
monitor.
The image
recorded in
the flash
mode is
dark.
Cause
Camera is shut off.
Batteries are exhausted.
Batteries are inserted with the
polarity reversed.
The CF card is not inserted into
the camera.
The auto power-off function has
timed out and shut off the camera.
The green focus lamp blinks
slowly and "PLAYBACK" blinks
on the LCD monitor.
Subject is out of the flash
range.
Page
18
25
25
29
18
29
44
28