Filter
Top Products
27
CHECKING THE BATTERY POWER
When the batteries are installed in the camera, the camera checks the battery power automatically
and shows the result on the data panel.
Battery power is no longer at peak performance and should be
monitored.
Batteries are exhausted. All indicators blink for 5 seconds then camera
shuts off.
• Replace exhausted batteries or...
• Remove exhausted batteries and use AC adapter 6V 1A (see page 28).
Taking a picture or playing back cannot be executed.
Battery power is sufficient.
* If the data panel is blank after replacing batteries, check the battery installation by verifying
polarity (+/-). If the data p
anel is still blank, the new batteries may be dead and should be
replaced.