Filter
Top Products
33
AXIS M1011/M1011-W/M1031-W - System Options
Bonjour
The network cameras include support for Bonjour. When enabled, the camera is automatically detected by operating systems
and clients that support this.
Ports & Devices
I/O Ports
This page shows the normal and current state of the PIR Sensor.
PIR Sensor
PIR Sensor State - This setting shows the current state of the PIR Sensor.
Sensitivity Settings - Sensitivity Settings is used to adjust the sensitivity of the PIR Sen
sor from 0 - 100%. The default
sensitivity is 75%.
By increasing the sensitivity, the range of the PIR Sensor is also incr
eased. The PIR Sensor can be configured to detect
movement in the dark up a maximum range of 6 meters. Move the Sensitivity slider to adjust the PIR Sensor’s sensitivity and
range.
LED Settings
The Status indicator LED on the front of the camera can be set to flash at a configurable interval (or to not light up at all)
when the unit is accessed. For a listing of all LED behavior, see page 6, or the online help .
Notes:
•
The illumination LED is not intended for constant operation, and has an estimated life span of 30 000 hours.
• The LED can not be replaced.
• The LED should only be used for short periods when viewing video or when motion is detected.
Maintenance
• Restart - the camera is restarted without changing any settings.
• Rest
ore - the unit is restarted and most current settings are reset to factory default values. The settings that do not reset
are:
• the boot protocol (DHCP or static)
•
the static IP address
• the default router
•the subnet mask
• the system time
• Def
ault - the default button should be used with caution. Pressing this returns the camera's settings to the factory
default values (including the IP address).
Upgrade Server - See Upgrading the Firmware, on page 36.
Support
Support Overview
The Support Overview page provides valuable information on troubleshooting and contact information, should you require
technical assistance.