Filter
Top Products
AutoDome Modular Camera System VG4 Firmware Updates via the CTFID | en 21
Bosch Security Systems, Inc. Firmware Update Manual F.01U.097.269 | 1.06 | 2011.09
3. Navigate to the location of the firmware update file.
4. Select the appropriate file for your Device Model and Video Type; then click OK.
Figure 2.10 Select VG4 100 Series Firmware Image File
The CTFID displays a message warning you that the firmware update process erases all
device settings and returns the settings to the factory default value.
5. Click OK to accept the warning and to start the update process.
The CTFID begins the firmware update and marks the update progress at the bottom of
the screen. This process may take several minutes to complete.
6. Once the firmware update is complete, the CTFID displays a message that the firmware
update was successful.
7. Click OK to confirm the message.
8. The CTFID reloads the settings from the camera and displays the Device Information
screen.
9. Ensure that the Firmware Version field reflects the new firmware version.
2.5.2 Uploading a VG4 200 or VG4 300 Series AutoDome Service Pack
The table below summarizes the information for the first full production versions of the VG4
AutoDome firmware.
If the AutoDome receiving an upgrade contains firmware older than the files above, then the
AutoDome is considered a pre-production model. Service packs may not properly update a
pre-production model. If you do need to update a pre-production model, follow the special
instructions in Section 3.1 Pre-production Firmware Versions (All Models), on page 31.
Component First Released Version Release Date
SCBootApp.g4i 01.00.00.01 November 2006
SCmain.g4i 01.00.00.02 November 2006
VCA_app.g4i 01.00.00.01 April 2007
VCA_boot.g4i 00.06.00.00 April 2007