Filter
Top Products
AutoDome 700 Series IP PTZ Camera Configuring the AutoDome 700 Series | en 31
Bosch Security Systems, Inc. User Manual F.01U.215.777 | 1.0 | 2011.07
P-frame Quality
This setting allows you to adjust the maximum image quality of the P-frames. The basic setting
Auto automatically adjusts to the optimum combination of movement and image definition
(focus). Alternatively, you can use the slide control to set a value between 9and51. The value
9 represents the best image quality with, if necessary, a lower frame refresh rate depending
on the settings for the maximum data rate. A value of 51 results in a very high refresh rate and
lower image quality.
Default
Click Default to return the profile to the factory default values.
4.20 Encoder Streams
Select the property and default profile for each H.264 stream and set the parameters for the
M-JPEG stream.
– H.264 BP+ bit-rate-limited
Select this setting when using hardware decoders. The bit rate is limited to 1.2 Mbps.
CABAC: off
CAVLC: on
GOP structure: IP
I-frame distance: 15
Deblocking filter: on
– H.264 MP SD
Select this setting when using software decoders, PTZ and for rapid movements in the
images.
CABAC: on
CAVLC: off
GOP structure: IP
I-frame distance: 30
Deblocking filter: on
To select the stream options:
1. Select the required encoder properties and one of the encoder profiles for each data
stream.
2. Click the Preview button. The preview screens for both data streams are shown.
3. Click the 1:1 Live View button below the preview screen to open a new window with the
original data stream and to check the image quality and the transmission rate.
Property
Select one of the H.264 standards for each stream.
Default profile
Select one of the following profiles for each stream:
– High resolution 1
– High resolution 2
– Low bandwidth
–DSL
–ISDN (2B)
–ISDN (1B)
–Modem
–GSM
Refer to Section 4.19 Encoder Profile, page 28, for more details about each stream.