Filter
Top Products
62 en | Troubleshooting Guide AutoDome 700 Series IP PTZ Camera
F.01U.215.777 | 1.0 | 2011.07 User Manual Bosch Security Systems, Inc.
Problem Solution
No Audio – Check the computer receiving the audio from the VG5 AutoDome or from the IP
Encoder.
– Check the computer’s audio settings. Ensure that the sound levels are at an audible
level.
– Check the computer’s audio output card and speakers. Play a secondary source of
audio on the computer. If you still do not hear audio replace the speakers and try
again.
If O.K., then:
– Ensure that the Audio option is enabled for the IP device.
a. Access the Settings Web page for the IP-enabled device.
b. Expand the Encoder Settings link, then click Audio Settings.
c. Ensure that On is selected from the Enable Audio drop-down list. Then, click Set.
If O.K., then:
– Check the microphone.
Connect appropriate speakers directly to the microphone at the camera site and
confirm that the audio is clear and audible at the location.
An audio problem or noise at the source will further degrade as it travels through all the
cables and connections.
If O.K., then:
– Verify the cable type and installation used for audio connections between the
microphone and the VG5 AutoDome.
– Cable type: Coaxial
– Cable length: 10 m (33 ft), maximum
Refer to the VG5 AutoDome Installation Manual for more information.