Filter
Top Products
AutoDome 700 Series IP PTZ Camera Configuring the AutoDome 700 Series | en 35
Bosch Security Systems, Inc. User Manual F.01U.215.777 | 1.0 | 2011.07
4.23 Lens Settings
Auto Focus
Continuously adjusts the lens automatically to the correct focus for the sharpest picture.
– One Push (default): activates the Auto Focus feature after the camera stops moving.
Once focused, Auto Focus is inactive until the camera is moved again.
– Auto Focus: Auto Focus is always active.
– Manual: Auto Focus is inactive.
Focus Polarity
– Normal (default): focus controls operate normally.
– Reverse: focus controls are reversed.
Focus Speed
Controls how fast the Auto focus will readjust when the focus becomes blurred. Select from
the following options:
– Super Slow
– Slow (default)
– Medium
– Fast
Auto Iris
Automatically adjusts the lens to allow the correct illumination of the camera sensor. This type
of lens is recommended for use where there are low light or changing light conditions.
– Constant (default): camera constantly adjusts to varying light conditions (default).
If you select this option, the AutoDome makes the following changes automatically:
– Gain Control: switches to AGC.
–Shutter Speed: switches to default.
– Manual: camera must be manually adjusted to compensate for varying light conditions.
Iris Polarity
Capability to reverse the operation of the iris button on the controller.
– Normal (default): iris controls operate normally.
– Reverse: iris controls are reversed.
Auto Iris Level
Increases or decreases brightness according to the amount of light. Type a value between 1
and 15, inclusive. The default setting is 8.
Maximum Zoom Speed
Controls the zoom speed. The default setting is Medium.
Zoom Polarity
Capability to reverse the operation of the zoom button on the controller.
– Normal (default): zoom controls operate normally.
– Reverse: zoom controls are reversed.
Digital Zoom
Digital zoom is a method of decreasing (narrowing) the apparent angle of view of a digital
video image. It is accomplished electronically, without any adjustment of the camera's optics,
and no optical resolution is gained in the process. Select Off to disable or On to enable this
feature. The default setting is On.