Filter
Top Products
56 en | Configuring the AutoDome 700 Series AutoDome 700 Series IP PTZ Camera
F.01U.215.777 | 1.0 | 2011.07 User Manual Bosch Security Systems, Inc.
NTCIP
Specifies a set of rules and protocols for organizing, describing and exchanging transportation
management information between transportation management applications and
transportation equipment such that they interoperate with each other.
Select a port for NTCIP and the Address from the appropriate drop-down lists.
UPnP
A set of networking protocols that permits networked devices to seamlessly discover each
other's presence on the network and establish functional network services for data sharing
and communications. Select On to enable this protocol.
TCP Metadata Port
Select a port and type a IP address for the sender.
4.50 Multicast
In addition to a 1:1 connection between an encoder and a single receiver (unicast), the
AutoDome 700 Series can enable multiple receivers to receive the video signal from an
encoder simultaneously. The device either duplicates the data stream itself and then
distributes it to multiple receivers (Multi-unicast) or it sends a single data stream to the
network, where the data stream is simultaneously distributed to multiple receivers in a
defined group (Multicast). You can enter a dedicated multicast address and port for each
stream. You can switch between the streams by clicking the appropriate tabs.
A special IP address (class D address) must be configured for multicast operation in a
multicast-enabled network.
The network must support group IP addresses and the Internet Group Management Protocol
(IGMP V2). The address range is from 225.0.0.0 to 239.255.255.255.
The multicast address can be the same for multiple streams. However, it will be necessary to
use a different port in each case so that multiple data streams are not sent simultaneously
using the same port and multicast address.
Enable
To enable simultaneous data reception on several receivers you need to activate the multicast
function. To do this, check the box. You can then enter the multicast address.
Multicast Address
Enter a valid multicast address for each stream to be operated in multicast mode (duplication
of the data streams in the network).
With the setting 0.0.0.0 the encoder for the relevant stream operates in multi-unicast mode
(copying of data streams in the unit). The AutoDome 700 Series supports multi-unicast
connections for up to five simultaneously connected receivers.
NOTICE!
Multicast operation requires a multicast-enabled network that uses the UDP and the Internet
Group Management IGMP protocols. Other group management protocols are not supported.
The TCP protocol does not support multicast connections.
NOTICE!
The settings must be made individually for each stream.