Filter
Top Products
100
E
Editing
1. Find a point on your recorded cassette slightly before the section you wish to
copy and set it to playback pause mode.
2. Press the camcorder’s REC PAUSE button.
• The camcorder enters record pause mode.
3. Start playback on the other digital device while you monitor the picture.
4. Press the e/a (play/pause) button on the camcoder or the PAUSE a button on
the wireless controller.
• Recording starts.
5. When you get to the point where you wish to stop recording, press the stop
button or the pause button.
• Recording stops.
6. Stop playback on the other device.
Notes:
• If the cable is not connected properly, or if the cable is not connected when you press REC
PAUSE, the camcorder displays the caution ‘‘CHECK THE DV INPUT.’’ An anomalous image may
also flash onto the screen.
• Blanks between recordings on the playback tape are recorded as anomalous images on the tape
that is being recorded to.
Certain pre-recorded software tapes are copyright protected. If you try to play back such a cassette,
“COPYRIGHT PROTECTED PLAYBACK IS RESTRICTED” appears in the viewfinder for a few seconds
and then the camcorder displays a blank blue screen; you cannot view the contents of the cassette.
If you try to record from such a tape via the digital cable “COPYRIGHT PROTECTED DUBBING
RESTRICTED” appears in the display; you cannot record the contents of the tape.
Copyright signal
Dubbing