Filter
Top Products
19
E
Preparations
The cassette memory function cannot be used with this camcorder.
To protect your recording from accidental erasure, slide the tab on the cassette so that it exposes
the hole. (This switch position is usually labeled SAVE or ERASE OFF.)
If you load this cassette and put the camcorder in record pause mode ( 35), “THE TAPE IS SET
FOR ERASURE PREVENTION” is displayed for approx. 4 seconds and then the v mark flashes in the
display. The camcorder also shows the above phrase if you accidentally press the 2 (record) button
with the camcorder switched to TAPE PLAY (VCR) mode.
If you wish to record on the cassette again, slide the tab back so that the hole is closed.
Protecting Tapes from Accidental Erasure
SAVE
REC
SAVE
REC
Cassette Handling Precautions
Cassette Memory Function
•To protect the tape heads, transfer cassettes directly from the tape case to the camcorder — do
not open the tape protect cover or touch the tape itself.
• Do not use cassettes where the tape has been damaged or spliced — they may damage the
camcorder.
• Do not insert anything into the small holes on the cassette or cover them with cellophane tape.
• Handle cassettes with care — dropping them or exposing them to external shocks may cause
internal damage.
• Store cassettes in the provided case, rewinding them to the start of the tape first, and then
storing them upright.
•A cassette with metal plated terminals may become dirty with use, affecting information transfer.
Therefore, after using a tape around ten times, be sure to clean the terminals with a cotton
swab.