Filter
Top Products
153
E
Additional
Information
Caution Phrases
Time zone, date and time are not set. This message appears
each time you turn the power on until you set the time zone,
date and time ( 32).
Battery pack is exhausted. Replace or charge the battery pack.
Replace the tape or change the position of the protect switch
on the cassette ( 18, 19).
The camcorder stopped operating to protect the cassette.
Remove the cassette and retry the operation from the
beginning ( 142).
DV cable is not connected, or the connected digital device is
turned off ( 99).
Condensation has been detected in the camcorder ( 142).
Tape reached the end. Rewind or remove the tape ( 88).
Recording is made in a mode other than the SP mode. Audio
dubbing or AV insert not possible ( 105, 108).
Recording is made in 16-bit or 12-bit 4-channel mode. Audio
dubbing not possible ( 108).
Camcorder detected a blank section on the tape. Audio
dubbing or AV insert not possible ( 105, 108).
Displayed immediately after you start recording when the video
heads are dirty. Clean the video heads ( 141).
You attempted to playback a copyright protected tape
( 100).
The camcorder displays various caution phrases for approx. 4 seconds.
SET THE TIME ZONE,
DATE AND TIME
CHANGE THE BATTERY PACK
THE TAPE IS SET FOR ERASURE
PREVENTION
REMOVE THE CASSETTE
CHECK THE DV INPUT
CONDENSATION
HAS BEEN DETECTED
TAPE END
CHECK THE CASSETTE
[REC MODE]
CHECK THE CASSETTE
[AUDIO MODE]
CHECK THE CASSETTE
[BLANK]
HEADS DIRTY,
USE CLEANING CASSETTE
COPYRIGHT PROTECTED
PLAYBACK IS RESTRICTED