Filter
Top Products
145
E
Additional
Information
Memory Card Operations
Cause and/or what to do about it
• It is not turned the right way ( 115).
Turn it the right way and try inserting again.
•Turn the camcorder’s power off and back on
again and remove and reinsert the card. If the
mark continues to flash, format the memory
card.
• The camcorder is not set to CARD CAMERA or
CARD PLAY (VCR) mode ( 118, 120).
• The memory card is not inserted ( 115).
•You are using an SD Memory Card and it is set
for erasure prevention. Change the position of
the protect switch.
• The memory card is full. Erase images ( 122)
or insert a new memory card.
• The power source is not properly connected, or
the battery pack is exhausted or not properly
attached ( 16-17, 137).
• The function cannot be used in that recording
program ( 52).
• The memory card is not loaded ( 115).
•You are using an SD Memory Card and it is set for
erasure prevention. Change the position of the
protect switch.
• The memory card is full. Erase images ( 122)
or insert a new memory card.
•You have reached the maximum file number. Set
the file numbering to RESET through the menu
( 117) and insert a new memory card.
•You are using an unformatted memory card.
Format the card ( 133).
• The image is protected ( 122).
•You are using an SD Memory Card and it is set
for erasure prevention. Change the position of
the protect switch.
Problem
? The memory card will not insert.
? The mark flashes red in the display
even though a memory card has been
inserted.
? Nothing happens when I press the
buttons.
? The PHOTO button does not work.
? The image cannot be erased.