Filter
Top Products
APPENDIX
138
Other
Symptom Possible Cause Action
This camera cannot display non-DCF images re-
corded onto a memory card using another digital
camera.
Remove the battery from the camera, reinsert it,
and then try again.
1) After confirming that the computer is not access-
ing camera memory, disconnect the USB cable.
2) Press DISP to turn on the monitor screen.
1) Check all connections.
2) Install the USB driver on your computer (page
110).
3) Turn on the camera.
Images are not displayed.
All buttons and switches are
disabled.
Monitor screen is off.
Cannot transfer files over a
USB connection.
A memory card with non-DCF images recorded with
another camera is loaded in the camera.
Circuit problem caused by electrostatic charge, im-
pact, etc. while the camera was connected to an-
other device.
1) USB communication is in progress.
2) The monitor screen is turned off (in a recording
mode).
1) USB cable is not connected securely.
2) USB driver is not installed.
3) Camera is turned off.
Playback