Filter
Top Products
2-16
Cisco Video Surveillance System 2621 IP Dome User Guide
OL-24129-02
Chapter 2 Getting Started
Installing the Cisco Video Surveillance 2621 IP Dome
Mounting to a Ceiling Tile
You can mount the IP dome in a ceiling tile. The ceiling tile must be able to support at least three times
the weight of the IP dome. An optional ceiling tile mounting plate is available to reinforce a ceiling tile
so that the tile provides adequate support. You can purchase the ceiling tile mounting plate from Cisco
(Cisco part number CIVS-IPCA-1007=).
To mount the IP dome to a ceiling tile, perform the following steps. Make sure that the location in which
you install the IP dome can support at least three times the weight of the IP dome.
Note When you disassemble the IP dome for mounting as described in these steps, make sure to remove any
protective packing material that is installed between components.
Procedure
Step 1 Remove the dome assembly by unscrewing the three security TORX screws and pulling the dome away
from the base plate (see
Figure 2-11).
Use the TORX screwdriver that is provided with the IP dome to unscrew these screws.
Step 2 Remove the Privacy shield by squeezing it inward to release it from the four tabs that hold it into place
(see
Figure 2-11).
Step 3 Remove the camera unit from the base plate by using a Phillips-head screwdriver to unscrew the two
camera unit screws and pressing the tabs that lock the camera unit to the base plate (see
Figure 2-11).