Filter
Top Products
2-18
Cisco Video Surveillance System 2621 IP Dome User Guide
OL-24129-02
Chapter 2 Getting Started
Installing the Cisco Video Surveillance 2621 IP Dome
Figure 2-12 Preparing the 2621 IP Dome Ceiling Tile
Step 5 Place the ceiling tile mounting plate over the ceiling tile.
Orient the ceiling tile mount so that it is flush with the back surface of the ceiling tile.
Step 6 Attache the base plate to the ceiling tile and ceiling tile mounting plate using four screws.
Step 7 Put the an category 5 or higher Ethernet cable through the appropriate cable entry hole in the conduit
base and connect the cable to the LAN port on the IP dome (see
Figure 1-1 on page 1-3).
Caution Do not lift the IP dome by the Ethernet cable.
Step 8 If the IP dome will not receive PoE, put the power cable through the appropriate cable entry hole in the
conduit base and connect it to the power input on the IP dome (see
Figure 1-1 on page 1-3).
To connect a power cable, use a flat-head screwdriver to depress the brown tabs on the power input and
connect bare positive, negative, and ground wires as shown on the label that is affixed to the IP dome.
1 Ceiling tile mounting plate
2 Ceiling tile
3 Holes in ceiling tile
4 Base plate
1
2
3
4