Filter
Top Products
E16
Powering the Digital Video
Loading the Battery
3.7V Rechargeable Lithium-ion Battery.
1. Open the battery cover by sliding it in the
direction shown.
2. Load the battery and close the battery
cover.
How to recharge the battery
z Use the AC Adapter to recharge the battery.
Turn off the Digital Video, then connect the AC Adapter cable to (DC IN) jack of
the DV, and insert the power plug into a power outlet. The battery will be
recharged through AC Adapter.
z Use the USB to recharge the battery.
Turn off the Digital Video, then connect the Digital Video to PC, the battery will
be recharged through the USB cable.
Note
z Use only specified 3.7V rechargeable Lithium-Ion battery for this camera.
z When the battery symbol is (near end), it indicates that the batteries
are nearly exhausted. Be sure to have spare batteries on hand.
z NOT ALL BATTERIES ARE THE SAME! Battery life depends significantly
on battery age, usage conditions, type, and brand.
z Battery performance is reduced at temperatures below 41 °F (5 °C).
Note for Recharging Battery
1.LED Status: (A)during recharging, the LED is red, (B) LED is not lit when
charging has been completed, (C) if under voltage, the LED is green, (D) if
the battery temperature is abnormal the LED is orange (if, without battery,
use the AC Adapter as the power source , the LED is also orange, but it is
normal).
2. For LED status (C), please change the battery.
3. For LED status (D), please disconnect the AC Adaptor and remove the
battery, wait until the battery cools down and try again.