Filter
Top Products
62D-Link DCS-3415 User Manual
Section 4 - Configuration
With the digital PTZ (Pan/Tilt/Zoom) feature enabled, it is possible to
zoom in and out from the DCS-3415.
Enable PTZ Operation
To utilize this feature, please connect the DCS-3415 to a PTZ scanner via RS485
interface and follow the instructions given below. The DCS-3415 offers three PTZ
drivers:
• DynaDome/SmartDOME
• Lilin PIH-7x00
• Pelco D protocol
Note: If none of the above PTZ drivers are supported by your PTZ scanner, please
select Custom camera.
1. Connect to your PTZ scanner, set the Camera ID, PTZ driver and Port
settings.
2. Select Enable PTZ Operation and then click Save to take effect.
3. The PTZ control buttons will be displayed in the main page.
Preset Position
Click Preset Position to set the preset position for the Network Camera. A total of
20 preset positions can be configured.
To set a preset position, follow the steps given below:
1. Adjust the Network Camera to a desired position using
the buttons on the right side of the window.
2. In the Preset position name text box, enter a descriptive name for the
preset position. You can enter up to forty characters in the text box.
3. Click Add. The preset position name will appear in the drop-down list.
To remove a preset position from the list, select a preset position name from the
drop-down list and then click Delete.
RS485