Filter
Top Products
22
Setting Up Your Scanner
2. Turn the card over so that the circuit
board side is facing down, and insert it
in the optional interface slot. Push
gently until the card is firmly seated in
the expansion slot inside the optional
interface slot.
3. Tighten the retaining screws and
reconnect the scanner’s cables.
Connecting the IEEE 1394 Cable to Your Computer
The IEEE 1394 scanner interface card has two cable connectors. You can use either
one to connect the scanner directly to your computer. At the same time, you can use
the second connector to connect other IEEE 1394 devices in a daisy chain or tree
configuration. You can also connect the scanner to another IEEE 1394 device so that
it’s the last IEEE 1394 device in a chain connected to your computer.
Neither your scanner nor your computer has to be off when you connect the cable.
However, be careful not to connect or disconnect the cable when the scanner is in use.
Follow these steps to connect the
scanner:
1. Connect one end of the cable to
the IEEE 1394 port on the card.
2. Connect the other end of the
cable to the IEEE 1394 port on
your computer or on another
IEEE 1394 device.
circuit board, face down