Filter
Top Products
4-23
4.7 Replacing the Back-side Lamp
4
REPLACEMENT OF CONSUMABLES
5. Install the Back-lamp unit in the reverse order of its removal. Make sure
the connectors meet properly.
6. Close the side cover. Confirm that the cover is closed securely.
7. Clear the Rear-side lamp counter.
Please refer to the section “7.3 Setup Mode Details”, “ 9. Abrasion counter
(Abrasion CNT) reset ” on page 7-34.
HINT
You can check the cumulative lamp-on time from the Operator panel Test
mode.
For the details, refer to the section "7.5 Test Mode Details", "3.Display the
cumulative lamp-on time" on page 7-79.