Filter
Top Products
7-57
7.3 Setup Mode Details
7
OPERATOR PANEL MENUS
5) At <Screen25-3>, you can specify if the numbering should be initialized to the
specified initial value in 4) at hopper empty.
To specify to initialize the numbering counter at hopper empty, press (Left
arrow button) and select [On].
Press (Enter button) to confirm the selection. Then, <Screen25-4> is
displayed.
To specify not to initialize the counter at hopper empty but continue
incrementing, select [Off], press (Enter button) and then <Screen 25-4>
is displayed.
<Screen25-4>
6) At <Screen25-4>, specify if the numbering counter should be initialized
immediately to the vlaue specified in 4).
To specify to initialize immediately, press (Right arrow button) and select
[Yes].
To specify not to initialize immediately, select [No] and press (Enter
button).
7) Press (Enter button) to confirm the setting.
Press (Exit button), and the LCD display goes back to [Ready] screen.
ATTENTION
Command from the PC takes the priority over the setting from the Operator
panel.
2
5
N
R
!
o
e
-
Y
4
e
t
es
=N
/
o
s
w