Filter
Top Products
7-26
7.3 Setup Mode Details
5. Setting Double-feed detection (by document length)
1) Press (Next button) or (Previous button) and let the scanner show
<Screen5>.
<Screen5>
2) At <Screen5>, by pressing (Left arrow button) or (Right arrow button),
Double-feed detection by document length can be enabled or disabled.
By checking the document length for partially over lapped sheets that are fed
together. In this screen, you can specify if the amount of length checking is
done, set the detection conditions, and select the error processing.
By pressing (Right arrow button), selection moves from (1) to (3).
By pressing (Left arrow button), selection moves from (3) to (1).
If you would like to disable the Double-feed detection, select [No] and press
(Enter button).
(1) [No] is blinking: Document length is not checked.
(2) [Yes] and [1] are blinking: Document length is checked.
However, scanning continues even if
Double-feed is detected and the error
message is displayed on the LCD.
(3) [Yes] and [2: Stop] are blink-
ing:
Document length is checked.
When double-feed is detected, scanning
stops. Then the error is reported to the
PC.
HINT
The blinking item is the one selected.
05
gn
!
t
hh
/
L
s
eYo
N
/
1J
e
C
otS:2
c
e
k
=p