Filter
Top Products
167
7.2 Setup mode functions
7
SETUP MODE
LCD
display
Descriptions Selectable
parameters
Default Mode Remarks
On-
line
Off-
line
Baud Rate Specifies the control
data transfer rate for
TPS interface.
19200/
9600/
4800/
2400
9600 Not
Avail-
able
Avail-
able
New setting
valid after
turning on
the power
again.
Imprinter When both fi-
486PRFR(Front
side/Pre-print) and
fi-486PRRE(Rear
side/Post-print) are
installed, specifies
which one to setup.
Pre/Post - Avail-
able
Avail-
able
-
Numbering When either fi-
486PRFR(Front
side/Pre-print) or
fi-486PRRE(Rear
side/Post-print) is
installed, set the
numbering parame-
ters.
Numbering
: On/Off
Digits
: 5/8
Initial No.:
5digit: 0-99999
8digit:0-
16777215
Reset at hop-
per empty: On/
Off
Numbering
: Off
Digits
: 5
Initial No.:
00000
Reset at
hopper
empty: On
Avail-
able
Avail-
able
Setup done
via the PC
has the prior-
ity.
Ink Shows the remain-
ing ink amount.
Reset remaining
amount ink counter
when the Print car-
tridge is replaced.
--Avail-
able
Avail-
able
-