Filter
Top Products
176
7.3 Setup Mode Details
5. Setting Double-feed detection (by document length)
1) Press (Next button) or (Previous button) and let the scanner show <Screen5>.
<Screen5>
2) At <Screen5>, by pressing (Left arrow button) or (Right arrow button), Double-
feed detection by document length can be enabled or disabled.
By checking the document length deviation when partially over wrapped two sheets are
fed. In this screen, you can specify if the length check is done, set the detection
conditions, and select the error processing.
By pressing (Right arrow button), selection moves from (1) to (3).
By pressing (Left arrow button), selection moves from (3) to (1).
If you would like to disable the Double-feed detection, select [No] and press
(Enter button).
(1) [No] is blinking: Document length is not checked.
(2) [Yes] and [1] are blinking: Document length is checked.
However, scanning continues even if Dou-
ble-feed is detected and the error message
is displayed on the LCD.
(3) [Yes] and [2: Stop] are blinking: Document length is checked.
When double-feed is detected, scanning
stops. Then the error is reported to the PC.
HINT
The blinking item is the one selected.
05
gn
!
t
hh
/
L
s
eYo
N
/
1
e
C
otS:2
c
e
k
=p