Filter
Top Products
207
7.3 Setup Mode Details
7
SETUP MODE
5) At <Screen25-3>, you can specify if the numbering should be reset at hopper empty.
To specify to reset the numbering at hopper empty, press (Left arrow button) and
select [On].
Press (Enter button) to confirm the selection. Then, <Screen25-4> is displayed.
To specify not to reset the numbering at hopper empty, select [Off], press (Enter
button) and then <Screen 25-4> is displayed.
<Screen25-4>
6) At <Screen25-4>, specify if the numbering should be initialized immediately.
To specify to reset immediately, press (Right arrow button) and select [Yes].
To specify not to reset immediately, select [No] and press (Enter button).
7) Press (Enter button) and make the setting valid.
Press (EXIT button) at <Screen25-1>, <Screen25-2>, <Screen25-3>,
<Screen25-4>, then the LCD display changes to <Screen25>.
Press (EXIT button) at <Screen25>, and the LCD display goes back to [Ready]
screen.
ATTENTION
Command from the PC overrides the setting from
the operator panel.
2
5
N
R
!
o
e
-
Y
4
e
t
es
=N
/
o
s
w