Filter
Top Products
18
The Admin utility allows users to search for and set up the network cameras located within the Intranet or on the Internet.
From the utility, users can view all of the selected cameras’ information. It also provides a Setting Wizard, which easily
guides users through the process of installing network cameras on the network. (Remember that you can also install
network cameras on the network using the Quick Setup Wizard that is located on the CD.) Please remember that you can
only use the Admin utility that is included with this network camera with similar cameras that are available on your
network. A “similar” camera will have the same code of four letters at the beginning of its serial number. This code is
“HEMT” and can be found on either the right or left panel of the camera packaging, or on the label on the bottom of the
camera.
There are two ways to run the Admin utility:
1. Click “Start”, and then select “Programs\IP Camera\Admin Utility” to run the utility.
2. Click on the “IP Camera Admin” icon
to run the utility.
Once you have initialized the utility, it will search for all similar cameras available on your network. To configure more
detailed settings, please refer to the descriptions in the sections that follow.