Filter
Top Products
9
4.2 Camera Ports
The back panel of the network camera includes three ports and a Reset button.
y Antenna Connector
This is a standard Reverse-SMA connector. Any antenna with a Reverse-SMA connector can be connected to the
network camera.
y Power
The “Power” port is where you will connect the network camera’s power adapter.
y LAN
The LAN port is where you will connect the Ethernet network cable.
y Reset
1. If a problem occurs with the network camera, but you do not want to reset it to its original default settings, press
the reset button for less than two seconds (using a pen or pencil tip, or something similar) and the network
camera will re-boot itself and keep your original configurations.
2. If a problem persists, you experience more severe problems, or you forgot your password, press the reset button
for longer than five seconds and the network camera will reset itself to the original factory default settings
(warning: your configurations will be replaced by the factory default settings).
Antenna
LAN
Port
Power
In
p
ut
Reset
Button