HP (Hewlett-Packard) P650 Digital Camera User Manual


 
42
NOTE
Spending a long time using movie recording will cause the camera to become
slightly warm to the touch. This is normal and does not indicate malfunction.
The camera also records audio. Note the following points when
shooting a movie.
Take care that the microphone is not blocked by your fingers,
etc.
Good recording results are not possible when the camera is
too far away from what you are trying to record.
Operating camera buttons while shooting can cause button
noise to be picked up in the audio.
Shooting a very bright subject can cause a vertical band or a pink cast on the
monitor screen image. This does not indicate malfunction.
When using the camera’s built-in memory or certain types of memory cards, it can
take too much time to record data, which can result in breaks in the image and/or
audio. This condition is indicated by and flashing on the monitor screen.
To avoid loss of movie frames, use of a memory card with a maximum transfer
speed of at least 10MB per second is recommended (page 108).
The effects of camera movement in an image become more pronounced when you
shoot close up or with a large zoom factor. Because of this, use of a tripod is
recommended under these conditions.
Microphone