52
Procedure
[ ] (REC) [SET] MENU REC Tab AF Area
IMPORTANT!
• Selecting “
Tracking” can cause vibration and noise to occur due to lens
operation while tracking a subject. This does not indicate malfunction.
Procedure
] (REC) [SET] MENU REC Tab AF Lamp
The AF Lamp function allows you to record images even low light conditions.If AF
Lamp is set to Auto, the AF lamp located in the front of the camera, emits an red light
by half pressing the Shutter button allowing the camera to focus easily.
IMPORTANT!
• Use [ ] and [ ] to go through the selection. Press the [SET] button to save and
apply changes.
Specifying the Auto Focus Area (AF Area)
Spot
This mode takes readings of a small area in the center of the
image.
Multi
When you half-press the shutter button while this setting is
selected, the camera will select the optimum Auto Focus area
from among nine possible areas. The focus frame of the area
where the camera focuses will be displayed in green.
Tracking
Half-pressing the shutter button focuses on the subject and
causes the focus frame to track the movement of the subject.
Using the Auto Focus Lamp (AF Lamp)
“ Spot” or “
Tracking”
Focus frame
Focus frame
“
Multi”