English
57
MACRO RECORDING
Use the macro function when recording a small object from close-up position: You can shoot the subject
as close as approximately 13/16” (2 cm) from the lens surface, magnifying the image to fill the screen.
1 Aim the DVD video camera/recorder at the
subject, and press down the zoom lever to “W”
control side.
Note:
• Zoom can be used, but the subject may not be focused,
depending on the distance to the subject. In this case,
move the zoom to “W” control side to focus.
• The amount of light tends to be insufficient during macro
recording: If the subject image is too dark, use additional
lighting.
RECORDING SUBJECTS FOR STRONGER WIDE-ANGLE OR TELEPHOTO
EFFECT
Use tele-conversion lens or wide-conversion lens with a filter diameter of 37 mm and thread pitch of 0.75
mm, to record subjects for stronger telephoto or wide-angle effect.
1 Remove the lens hood from DVD video
camera/recorder.
2 Remove the cap of conversion lens, and screw
the lens into the filter thread of DVD video
camera/recorder until it stops.
• Tele-conversion lens (DZ-TL1): For stronger telephoto effect
• Wide-conversion lens (DZ-WL1): For stronger wide-angle effect
Note:
• Be careful not to lose the removed lens hood.
• With DZ-TL1 tele-conversion lens, the focusing range at
“T” (telephoto) control side is between approx. 5 m and
infinite.
• When a conversion lens is attached, note that if you
zoom in on a subject, vignetting will slightly occur on the
“W” (wide-angle) control side (the four corners of screen
will be dim).
• When replacing the lens, take care not to drop the DVD
video camera/recorder.
(Attach)
Conversion lensLens hood
(Remove)