Filter
Top Products
Network Video Server User’s Guide
73
J. Reinstating the Factory Default Settings
This information explains instructions in detail on how to set the default settings in the NETWORK
VIDEO SERVER. In certain circumstances it may become necessary to restart or reinstate the
Factory Default settings for your NETWORK VIDEO SERVER: This is performed by pressing the
Reset Button, or using Hyper Terminal Setting. Follow these instructions to reinstate the product
factory default settings
Using the Administrator Menu
① Login to NETWORK VIDEO SERVER.
② Open the Administrator Menu.
③ Open the System Configuration Page.
④ Press the “RESTORE DEFAULTS” button.
Using Hyper Terminal
① Execute “Hyper Terminal” as
referred to Chapter “4.3.1
Configuring Hyper Terminal”
② Supply the power to the
NETWORK VIDEO SERVER.
③ After a while, the count down
starts with the message
“Press 'p' key to stop auto-boot or
Load-Default-Button under the
NetCam for 3 seconds...”
.At this time, press ‘p’ key. Then,
[NETWORK VIDEO SERVER
Boot] prompt shows like the right
side image.
④ When you enter ‘w’, Administrator ID & Password reinstate as factory default ‘admin’